Navigate to the Miranda's internal configuration website by typing the IP into your browser's URL bar. This will allow you to configure the network, as well as see the status of the Patch and Cuestack loaded onto this device.

Summary Tab

The Summary tab includes basic information about the device. The Reboot button functions, but the Identify button is not yet implemented.

Network Tab

The Network tab lets you configure the network settings. Please note that the Enable DHCP checkbox takes precedence over the Static IP settings.

Network Tab Settings

• Enable DHCP: if checked, this will enable DHCP.
• Static IP: this is the dotted-quad static IP address for the device.
• Netmask: this is the netmask in dotted-quad format. If you are used to CIDR format:
  • /8 is 255.0.0.0
  • /16 is 255.255.0.0
  • /24 is 255.255.255.0
• Gateway: this is the IP address of the router to get internet access.
• DNS server is automatically set to 8.8.8.8. If this is unroutable due to network policy, please use DHCP as the current workaround, but please let us know.
• Save Settings will save the network settings, but they will not take effect until the controller is rebooted with the "Reboot" button on the Summary page.

Output Tab

The Output tab will allow you to configure the DMX ports as well as the sACN settings. This page is not currently implemented in the firmware.

Patch Tab

The Patch tab shows you the current patch file including Fixture Id, Label and start address. Of note, Start Addresses 1-512 are Universe 1, Addresses 513-1024 are Universe 2.

Features is not strictly functional at the moment, but intends to show what attributes are available on each fixture.

Cuestacks Tab

The Cuestacks tab provides a table of the current cuestack file loaded. This includes the Stack ID, Label, number of steps in the cuestack, and total duration in milliseconds.

The Control buttons are not yet implemented.